- Pull-Through Soap Shapers
- >
- NEW Mini Kaleidoscope Soap Shaper Set of 4 (Acrylic)
NEW Mini Kaleidoscope Soap Shaper Set of 4 (Acrylic)
🍁 Made in Vancouver, Canada
📦 Ships worldwide
Prices are in Canadian Dollars. To our U.S. customers – don't forget that the exchange rate works in your favour, it's like an extra discount.
🎥 Watch the HOW-TO Video Below! 👇
Set of 4 Mini Kaleidoscope Soap Shapers for use with slab molds and for the pipe divider technique. Each Mini Kaleidoscope design plate can also be used with the full length Soap Shaper Pull-through Stems which can be purchased separately here >
2 sizes available:
– 2.16 in / 55 mm
– 1.73 in / 44 mm
Order any combination of these 2 sizes in your set of 4
Or select a custom size between 1.73 in / 44 mm and 2.16 in / 55 mm and I'll resize to your requirements at no additional charge. Here's an easy step-by-step guide on how to measure your mold >
Choosing Size/s
Select the size that is slightly narrower than the PVC pipe or coupling you are using and be sure to factor in any narrower sections commonly found on the inside of PVC pipe coupling pieces.
INCLUDED IN EVERY ORDER
- 4 x Mini Kaleidoscope Design Plates in your choice of size – 2.16 in / 55 mm or 1.73 in / 44 mm in any combination (make your selections below)
- 4 x Stainless Steel Mini Stem & Bolts Sets: 3 in / 76.2 mm – 4 threaded stainless steel stems + 2 stainless steel nuts included for each stem (8 total).
- An introduction letter containing directions, tips and tricks is included in every order, to help you get started.
Soap Shapers are 3D-printed with PLA filament – an environmentally friendly choice. PLA is a durable material derived from crops such as corn and sugarcane. It's renewable and biodegradable. Colours may vary.
CARE INSTRUCTIONS
HAND WASH ONLY with care in lukewarm water (30 C / 86 F) and dish soap. Towel- or air-dry. Soap Shapers are NOT dishwasher safe. PLA is heat sensitive; exposure to excess heat may cause melting and/or warping. Avoid temperatures of 60 C / 140 F and higher.