Skull Cutter + Stamp Set
$35 CAD / $27 USD
(variable based on current exchange rate)
Prices are listed in Canadian dollars.
Included in each set
1 x Skull cutter – 1.73 in (w) x 2.55 in (h) with a depth of 1.18 in
1 x Eyes cutter
1 x Eyes push (use this tool to the push soap through Eyes cutter. Also use it as a stamp)
1 x Skull detail stamp
⭐️ Check out the video below from the talented Lilasuds ⭐️
Designed for cold process soap makers of all levels. Must have a basic understanding of cold process soap making and safe lye handling practices. An introduction letter containing directions, tips and tricks is included in every order, to help you get started.
Please allow up to 2 weeks for your made-to-order Set to be produced. Note: Each Set takes over 5 hours to produce.
Soap Shaper tools are 3D-printed with PLA filament – an environmentally friendly and skin-safe choice. PLA is a durable material derived from crops such as corn and sugarcane. It's renewable and biodegradable. Colours may vary.
HAND WASH ONLY with lukewarm water (30 C / 86 F) and dish soap. Towel- or air-dry. Soap Shapers are NOT dishwasher safe. PLA is a heat sensitive; exposure to excess heat may cause melting and/or warping. Avoid temperatures of 60 C / 140 F and higher.